![Modelsim altera starter edition](https://kumkoniak.com/19.jpg)
Then you probably need to build a new version of freetype, a font setting library and modify ModelSim to use it. Problem number two: If you have the following error when running vsim: ** Fatal: Read failure in vlm process (0,0) Sudo apt-get install gcc-multilib g -multilib \Įxpat:i386 fontconfig:i386 libfreetype6:i386 libexpat1:i386 libc6:i386 libgtk-3-0:i386 \ Luckily this is fully supported on a modern Linux like Ubuntu 14. On Linux this requires us to install the 32 bit versions of the libraries that it depends on. Problem number one: The free version of ModelSim Altera Edition is 32 bit only while the normal Linux PC will be 64 bit. This article mostly adapts the work done by the Arch Linux crew. Luckily I had lots of helpful information on the internet (major sources linked below) to get it going. Trying to get a version of ModelSim running on a very modern version of Linux often presents challenges. Making ModelSim ALTERA STARTER EDITION vsim 10.1d work on Ubuntu 14.04 Download VIM editor (available in Software Center) before following the given solution.
![modelsim altera starter edition modelsim altera starter edition](https://www.thedrawingsource.com/images/5-ways-to-start-a-figure-drawing.jpg)
The instructions cited below work perfectly. This file contains all the commands and library inclusions the simulation requires.I've resolved the issue.
![modelsim altera starter edition modelsim altera starter edition](http://cdn-ak.f.st-hatena.com/images/fotolife/f/fixme/20150214/20150214223604.png)
In the ModelSim* - Intel ® FPGA Edition software, open the PLL_RAM_run_msim_rtl_verilog.do file.The Intel ® Quartus ® Prime software generates the PLL_RAM_run_msim_rtl_verilog_do file that defines the compilation and simulation instructions for the ModelSim* - Intel ® FPGA Edition simulator in the /simulation/modelsim/ directory in your project. Click Tools > Run Simulation Tool > RTL Simulation.do file, click Processing > Start Compilation. To compile the design and generate the.Enable Generate third-party EDA tool command scripts without running the EDA tool, and then click OK.
![modelsim altera starter edition modelsim altera starter edition](https://mir-s3-cdn-cf.behance.net/project_modules/max_1200/5c90f812320483.562667ca766b0.jpg)
- Click Assignments > Settings > EDA Tool Settings > Simulation > More NativeLink Settings.
-
The project opens in the Intel ® Quartus ® Prime GUI.
- To open the example design project, click File > Open Project, select the pll_ram.qpf project file, and then click OK.
- do file that runs the ModelSim* - Intel ® FPGA Edition simulator from the command line.